DS RGB PC Case Lighting LED Strip Kit.
The controller has 16 predetermined colors that are bright and distinguishable with 4 lighting effect, being strobe, flash, fade, and smoth.
The control box comes with adhesive foam tape on the bottom.
The power cable was a SATA to 12V cable instead.
The strip has no adhesive at all but attaches to the case via quarter of an inch magnets that inside the LED strip. These magnets are super strong, and do not sag or get pulLED down by the weight of the cables. They are even strong enough to hold the extra cables beneath them.

Specification
Color: RGB
LED Strip: 19.7inch(with 7.9inch Cable) / 50CM(with 20CM Cable)
Number of LED Lights: 18 LEDs
LED Type: 5050 SMD LED
Magnets: Black Sintered NdFeB Permanent Magnets
Extension Cable: 19.4 inch / 49.5CM
Power Connect Cable: SATA
Rated Voltage: DC 12V

Installation
1.Make sure that you have all the parts mentioned in the list.
2.Connect the SATA connector to PC power supply and other end to the IR control box.
3.Peel off the paper and stick the adhesive tape back in a proper position in the PC case.(Notice: IR receiver on the control box show be seen so that you can use remote controller change light colours.)
4.Connect 2 LED strip lights to the 4-pin ends with the extension cable.
5.Attach the strips well on the metal surface of the PC computer case.

Package Includes
2 x 30CM 5050 RGB PC Case LED Strip lighting
1 x SATA Connector Cable
1 x 24 key Remote
1 x Black IR Receiver Box
1 x 4Pin extension cable

Warranty

If you find your package in the courtyard, please check the product whether working perfectly before installation.
If the product have anything problem, please feel free to contact us, we will offer a replacement to you.