FEBRON Hair Building Fibers instantly give you the look of thicker, fuller hair. Made of natural, colored Fibers that are naturally statically charged, FEBRON Fibers intertwine with your existing hair for a completely natural look. FEBRON resists wind, rain and perspiration but removes easily with shampoo. FEBRON IS NOT LIKE ANY OTHER SO PLEASE READ CAREFULLY Please Follow The Exact Application Steps Below: 1).??Make sure your hair is completely dry and clean as well as your hands. Do not use hairspray, gel or mousse before application. Avoid applying in a humid place like in your bathroom just after taking a shower. 2).?? Shake the bottle onto the thinning area from VERY CLOSE (you can literally touch your scalp with the bottle) DO NOT SHAKE FROM FAR LIKE OTHER FIBERS. 3).?? VERY IMPORTANT THE "PAT & WIPE" TECHNIQUE: PAT the fibers with your palm to seal them stronger, then GENTLY WIPE the excess fibers that didn't attach to your hair strands with your fingers (this will eliminate any fallout). 4).??For extra bonding, use the Febron Fiberhold Spray. Shake the bottle well and apply the spray from 8 to 10 inches away then let it dry 20 -30 minutes (do not touch). COMMON MISTAKES TO AVOID???: ?MISTAKE 1: Fibers clump up - Avoid applying in a humid place. Make sure hair is completely dry and clean and use the ?PAT & WIPE technique?. ?MISTAKE 2: Hair looks dusty You need to use the ?PAT & WIPE technique? mentioned in the instructions section. ?MISTAKE 3: Hair too short or too thin - Your hair must be at least half inch long (1cm) for Febron to be effective. If your hair is very thin, the trick is to apply LESS product. Do not use on completely bald area. ?MISTAKE 4: Rolling on scalp - Please apply Febron fibers by shaking the bottle from VERY CLOSE but Do not rub the bottle on your scalp.