Gorilla clear grip is the crystal clear, holds in an instant contact adhesive. Gorilla clear grip is a flexible, fast-setting, crystal clear contact adhesive that creates a strong permanent bond. Gorilla clear grip is paintable and waterproof making it great for projects both inside and out! product features: ?permanent bond ?crystal clear ?fast grab: holds in just seconds ?100% waterproof: for indoor/outdoor ?No-Run formula ?paintable ?flexible ?washer & dryer safe ?photo safe Gorilla clear grip can be adhered to many surfaces including: wood, metal, stone, ceramic, glass, plastic*, PVC, brick, concrete, foam, paper, rubber, fabric, and laminate. *Note: not recommended for use on polystyrene, polypropylene or polyethylene products. Not for use on food contact surfaces. Do not dry clean. may cause damage to finished surfaces. Directions: all surfaces should be clean and free of dirt, grease and oil. Best if used between 50°f and 90°f. Clear grip should only be used in a well ventilated area. 1. Apply adhesive to each surface to be bonded. To maximize bond strength: wait approximately two minutes for adhesive partially dry before joining surfaces. 2. Press surfaces firmly together. Note: bond forms immediately and can be difficult to reposition. Cure time: allow for a minimum of 24 hours for full cure. Cure time may increase with lower temperatures and when used on non-porous surfaces. Storage tips: after each use, wipe nozzle with a dry cloth and tightly replace cap. Store in a cool, dry location. Tip: for easier re-opening, apply a thin coat of petroleum jelly to the threads before replacing cap. Store away from children and animals. Clean-up: wipe uncured adhesive with a dry cloth and clean with acetone, ISOPROPYL alcohol, or citrus based solvents according to manufacturer?s instructions. Cured adhesive may be removed by scraping from surface. Paintable when fully cured. Click on the Gorilla link at the top of this page to see other quality products from the Gorilla glue company.