Thermostat control outlet with the smart indicator light: The indicator light turns on when it's below 38 and it has energized the outlet. | Energize below 38℉(3℃) and to turn off automatically at approximately 50℉(10℃). Automatically turns power on and off according to ambient temperature. Save energy and save money | Easy installation: just plug this device into electrical outlet. Maximum 15 amps. CSA approved. Only for dry location. | Can be use for other applications: 120 VAC electric heaters, gas heater, Engine heaters, pipe heat tape, roof heating cable and so on | Make a test when you received the product. Put it into the freezer for 45 minutes. And then plug in and you will see the red light on the thermostat control. Two year limited warranty- If you are not completely satisfied with HEATIT ET-21, please don't hesitate to contact us in any time, we'll try our best to solve your issues.

CSA and ETL Certified for Peace of Mind: Our HIRD Roof Deicing Cable proudly carries CSA and ETL certifications, emblematic of superior quality and safety. Rest assured, these certifications affirm that our cable meets the most stringent industry benchmarks for both performance and safety. Count on our roof deicing cable to provide exceptional protection against snow and ice buildup, without compromise. Make the smart choice for quality and safety-choose a product that excels in every aspect. | 6 ft 18/3 cold lead with plug . Pre-assembled, ready to install, no maintenance required. Easy instruction manual, clips and spacers are included. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket. 100% screen rate with the Aluminum foil and tinned copper braid. More safe and more healthy. | Designed to prevent ice build up, known as ice dams, from forming on roofs and in gutters and downspouts. Protect your roof from damage and leaking, keep the water flowing in gutter & downspouts. | Used for Metal or plastic gutters/downspouts, Inclined roofs Roofs with noncombustible shingles (Ex.: asphalt shingles) that meet national building codes. Different lengths are available; Suitable for most roof and gutter configurations. | Testing the cable before the installation.Uncoil the heat cable completely so it does not touch, cross over or overlap on itself. Do not plug in the cable until it has been completely uncoiled. Plug cable in, and in approximately 5 minutes, you should feel slightly warm to the touch. Then unplug the cable.

JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. | Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. | Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap. | ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. | Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes.

JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. | Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. | Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap. | ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. | Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes.

JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. | Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. | Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap. | ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. | Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes.

Suitable for use on plastic and metal water pipes( including inlet pipe,drain pipe, sewer, palm tree frost protection etc). Industrial grade self regulating heating cable. The cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional. | Smart plug with indication light to show you whether the cable is working or not. Protect pipes up to 2 1/2” in diameter. For a better freeze protection, at least 1/2 inch thick or thicker insulation material is recommended, especially for extremely cold weather. If the ambient temperature is lower than -20°F(-29°C), please use 1” thick insulation material. ETL approved. 50 degrees F for pipe freeze protection.3 ft 18/3 cold lead with grounded plug. | Roof deicing application: HEATIT JHSF1 was designed to prevent the ice dam formation not to melt the ice dams which were already formed. Please turn on the cable at the beginning of snowing. Can be used on flat roofs, metal roofs, asphalt roofs, rubber roofs, slate roofs, stone roofs, metal roofs, ceramic roofs, composite (tar and gravel) roofs and so on. Rated 10W/ft at 32°F (0°C) for roof deicing. For roof deicing application, you may need to buy clips and hangers separately. | Designed to maintain water temperature in the supply piping system, reducing or eliminating the delay in obtaining hot water at each fixture. You don’t need to run showers or sinks for long periods of time to draw new hot water into the unit, which is a significant waste of water. Simply wrap the self regulating heating cable around your hot water lines within the house to provide you with instant hot water. It is an energy efficient and economical alternative to common re-circulation systems. | Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes.

Two year limited product quality warranty.If you are not completely satisfied with HEATIT hproducts, please feel free to contact us in any time, we'll try our best to solve your issue.