Faster:about 6 times than ByteblasterII
| USB interface:you don't need a PC with serial port
| Fast download speed,stable performance
| Support AS, PS and JTAG program ( with Verify and BankCheck function)
| Support all ALTERA products(CPLD：MAX3000、MAX7000、MAX9000 and MAXII;FPGA：Stratix 、StratixII、StratxIII、Cyclone、CycloneII and so on),100% compatible with Official ALTERA USB Blaster

This CE to SATA Adapter is recommended to be used for backups or direct data transfers. | One side of the CE to SATA Converter is ZIF / CE connector and another end is 7+15 pin SATA male connector. | No driver needed, this ZIF to SATA Converter is easy to install; Hot swappable, use without any driver. | Replace SATA hard disk driver with 1.8" ZIF version hard drive; Weight: 17g | Users of this product need to have high operating capabilities and high computing technology knowledge. If you need to use this product, but lack the corresponding operating ability, it is recommended that you first consult the document or operate under the guidance of the relevant technical personnel.

With input overvoltage protection, undervoltage protection, output overvoltage protection, output overcurrent protection, short circuit protection and other functions. | Network port speed: 10M / 100Mbps. Conducted interference In line with IEEE802.3 line power supply standards. | Lightning characteristics: AC input, can withstand 5KB, 8 / 20uS shock waveform, plus or minus 5 times, each time interval of 1 minute; power lightning protection circuit with failure warning function and safety protection components. | Compact, portable size with convenient wall plug design. Compatible with most 10 / 100Mbps IP camera, IP phone, Wireless IP point and other PoE devices. | POE port: connect the bridge, AP, CPE equipment WAN interface (power supply: 4,5 pin +, 7,8 pin -, 1,2,3,6 signal pin); LAN port: connect the router, switch or directly connected to the computer Host network interface (1, 2, 3, 6 signal pins)

The stepless speed regulator output voltage range smoothly changes between 3V-8V, so the fan wind speed can be adjusted, comfort greatly increased! | Turn the knob clockwise to increase the air volume. Turning it counterclockwise will make the air volume gentler and the knob has a switch function! | Usage: very simple! Insert the governor into the mobile phone charger or charging treasure, then insert the fan USB plug into the USB port of the governor, and then adjust the large volume of small air volume by turning the adjusting knob. | Input Power Supply Range: DC 4V to 12V ( USB port). Output range: DC 3V-8V (Not fit for 12V USB fan). | Rated power: 5W （Do not overload.）【Please check the second image on the left that is the use connection instructions.】

USB sound card, plug and play, free-drive. | If your computer's sound card is broken, you don't need to worry about it; just plug it in USB port directly. | Outputting an analog audio signal can directly drive headphones or output to active speakers. | Output / input: 3.5mm green headphone jack, 3.5mm microphone jack. | Chip model: CM108, External crystal.

The module is suitable for 3.3V TTL and RS422 signal mutual conversion, RS422 level is full-duplex level signal, the use of this module can be achieved SCM serial port and RS422 signal conversion. | With over-voltage and over-current protection circuit real-time protection RS422 level signal to protect the MAX490 chip's normal work. | The module except for the pin, Use SMD components to ensure better signal transmission, thereby enhancing the system EMC and other characteristics, the module as possible in more harsh environments. | With power and send & receive Indicator lights. The back of the product with wiring diagram. | NOYITO RS422 to TTL UART MCU Serial Port Signal Mutual Conversion Module https://1drv.ms/u/s!AlzQUCOyZQhKgWvO3IgUxJf-K4T7?e=dvf0zI

SN65HVD230 can be used under high interference environment. | The device has the ability to send and receive good at different rates. | Fully compatible with ISO11898 standard;High input impedance, allowing 120 nodes; Low current standby mode, the typical current of 370μA; Signal transfer rate up to 1Mb / s; | Thermal protection, open circuit failure protection function; With anti-instantaneous interference protection bus; Slope control, reduce radio frequency interference (RFI); | NOYITO SN65HVD230 CAN Bus Module Document Download https://1drv.ms/b/s!AlzQUCOyZQhKgSl45RkMeGcXgeHB?e=ECY7gg

Uses: TTL serial port communicates with RS232 level devices. Serial expansion of the device. RS232 port communication with Computer PC.
| Supports 3-5.5V power supply.15KV ESD Protect
| RS232 can choose male or female.
| The package contains six DuPont wires.
| Use high-quality chips. In order to facilitate the use of the product, each pin is marked, and a schematic diagram of the product is printed on the back of the product.

Uses: TTL serial port communicates with RS232 level devices. Serial expansion of the device. RS232 port communication with Computer PC | Supports 3-5.5V power supply.15KV ESD Protect | RS232 can choose male or female. | The package contains six DuPont wires. | Use high-quality chips. In order to facilitate the use of the product, each pin is marked, and a schematic diagram of the product is printed on the back of the product.

Uses: MCU's TTL serial port communicates with RS232 level devices. Serial expansion of the device. RS232 port communication with Computer PC. | Supports 3-5.5V power supply. | Size : 51 x 16 mm (LW) , Color:Blue. | In order to facilitate the use of the product, each pin is marked, and a schematic diagram of the product is printed on the back of the product. | Manufacturer's One-year After-sale Warranty.