Stainless Steel | Can Be Mounted Anywhere Jaws Can Fit | 180 Degree Swivel | Can Be Mounted to Either A Vertical or Horizontal Bar | Twist to Latch On or Release
PL-259 Male/Female on each end | Ground scew on side for easy grounding | For CB Antennas, Ham Radio, 2 way, ect.. | Lightning surge protector for coaxial cable | Attache between your radio and antenna for surge diversion
Quality Made by Workman. | Metal 3 Finger Style CB Radio Microphone Holder. | Fits Amateur, CB & Commercial 2-way radio mikes with rear "Button" hangar. | Includes Mounting Screws. | Lot of 2 units.
All Brass Construction SO-239 Stud Mount | Tapered Nut | Ends for 3/8 x 24 thread antenna and PL-259 Coax Cable | Uses Standard 1/2 inch hole for mounting. | Pack of 2
Measures power 0 -10 or 0 -100 watts. Frequency range 1.7 to 30 MHz. | Frequency range 1.7 to 30 MHz. Metal case is 5 x 2.5 x 2.5 inches | Field Strength antenna included. | SO-239 UHF connector on each end to connect to radio | Includes: 3' Black Workman CX-3-PL-PL Coax Jumper
Power Microphone With Tornado Echo Functions! | Fits Most CB Radios Having The Standard 4-Pin Mic Connector! | Delay & Reverb, Talkback & More! | Requires 1 9V Alkaline Battery ( Not Included). | Fits Most Cobra, Uniden, Galaxy, Connex, Superstar CB's! | Talkback will not work if you can receive when no mic is connected to the radio.
Measures power 0 -10 or 0 -100 watts. | SO-239 UHF connector on each end to connect to radio (jumper required) and antenna. | Field Strength antenna included. | Metal case is 5 x 2.5 x 2.5 inches. | Frequency range 1.7 to 30 MHz.
2-3/4 inch CB Extension Speaker is small but mighty. Compact enough to mount virtually anywhere in the cab without noticing it's there. Mylar Cone 8 Ohm Impedence 64" Speaker Cord 3.5mm Plug Mounting Bracket Hardware
REPLACEMENT BRACKET FOR COBRA 29 RADIOS AND OTHERS | BRACKET IS 7 1/4" WIDE | ( 2 ) REPLACEMENT 5mm BLACK PLASTIC KNOBS | ( 4 ) MOUNTING SCREWS | ( 2 ) RUBBER WASHERS TO GO BETWEEN BRACKET AND RADIO
Stop noise interference on auto power source feeds. | 3 pin plug for Uniden, Cobra, Galaxy and many other radios. | 12 Gauge Wire - 6 Feet Long. | 20 Amp Noise Filter. | Two fuse holders -Positive and Ground.