The HATMINI ARGB controller does not require motherboard support. It can be powered by directly plugging the power supply into the SATA interface. It has built-in multiple lighting modes and stable performance, allowing hosts that do not support 5V ARGB lighting synchronization to create bright and cool lighting effects
Applicable equipment: 5V ARGB equipment, such as chassis fans, lamps, light panels, air-cooled radiators, water-cooled radiators, etc.

M key: Click to switch to the next lighting mode, and you can cycle through the lighting modes that come with the controller
S key: Click to switch the light conversion speed. There are 8 levels that can be switched in a cycle. Press and hold the S key for 4 seconds to turn off the light, and then press and hold for 4 seconds to turn on the light.
C key: Click to switch other light colors in the same mode or reverse the light cycle. Press and hold the C key for 5 seconds to switch the light brightness. A total of 6 levels of brightness can be cycled

The 5V 3-pin interface has a protective cover to protect the needle from bending and deformation when it is not suitable

Lighting modes: colorful streamer, marquee, colorful cycle, monochrome breathing, etc.

Interface type: SATA /5V3PIN

Cable length 3PIN: 160(±10)mm SATA:500(±10)mm

What you get:
1 x 3Pin 5V ARGB controller cable